An Approach Transient Stability Analysis Using Equivalent Impedance Modified in 150 kV South of Sulawesi System
(1) * Muhammad Ruswandi Djalal   (Department of Machanical Engineering State Polytechnic of Ujung Pandang Makassar, Indonesia)
(2)  Herman Nawir   (Department of Machanical Engineering State Polytechnic of Ujung Pandang Makassar, Indonesia)
(3)  Herlambang Setiadi   (School of Information Technology & Electrical Engineering The University of Queensland Brisbane, Australia)
(4)  Andi Imran   (Department of Electrical Engineering Sepuluh Nopember Institute of Technology Surabaya, Indonesia)
(*) Corresponding Author
One of methods that can be used to determine the stability of a power system if the fault occured is the equal area criterion method. The equal area criterion method (Equal Area Criterion, EAC) is an example of a direct method for predicting the stability and also the critical clearing time (Critical clearing time). However, to calculate the complex calculations required to determine the equivalent impedance of each condition system. In this study used several approaches to facilitate the calculation of the equivalent impedance. This method uses the equation of power losses. This method is equivalent impedance using modified with Ploss and Qloss for Determining Pmax. From the analysis, it can be concluded the use of this method is quite accurate in analyzing or calculating the transient stability of the generator system in South Sulawesi, with each loading condition, before, during and after short circuit. Generator being looked at is Bakaru, Pare, Suppa, Barru and Sengkang.
Equal Area Criterion (EAC); Equivalent Impedance; Transient Stability; Critical Clearing Time
Full Text: FULLTEXT PDF INDONESIA
Article ViewAbstract views : 631 times | FULLTEXT PDF INDONESIA files viewed : 186 times
- There are currently no refbacks.
Copyright (c) 2017 Journal of Electrical and Electronic Engineering-UMSIDA
This work is licensed under a Creative Commons Attribution 4.0 International License.